Fusion Splicing is a preferred way to join two fibers together by using heat. Whether the fiber was broken or not long enough, a fusion splicer will make your job easier. Splicing fiber optic cable is a fairly simple procedure. Prepared fiber ends are placed in the splicer and automatically aligned and then fused together. This method ensures greater reliability with less light being scattered or reflected back by the splice and with the splice itself being as strong as the original optical fiber.ProcessThe process of fusion splicing normally involves heat to melt or fuse the ends of two optical fibers together. The splicing process begins by preparing each fiber end for fusion.
1. Stripping the fiberStripping is the act of removing the protective polymer coating around optical fiber in preparation for fusion splicing. The splicing process begins by preparing both fiber ends for fusion, which requires that all protective coating is removed or stripped from the ends of each fiber.Fiber optical stripping is usually carried out by simply passing the fiber through a mechanical stripping device similar to a wire-stripper. Otherwise, a special stripping and preparation unit that uses hot sulphuric acid or a controlled flow of hot air is used to remove the coating. there is a timed chemical removal process that does not require use of hot sulphuric acid or hot air. The process is patented as a "solvent capture method" primarily conceived to remove the "matrix" that holds individual fibers and creates a "ribbon fiber". This same procedure can be "timed" to remove not only matrix, but also coatings and claddings. Cleaning the stripping and cleaving tools is also important.
2. Cleaning the fiberThe customary means to clean bare fibers is with alcohol and wipes. However, high purity isopropyl alcohol (IPA) is hygroscopic: it attracts moisture to itself. This is problematic as IPA is either procured in pre-saturated wiper format or in (host) containers ranging for USA quart to gallon to drums. From the host container the IPA is transferred to smaller more usable containers. The hydroscopic nature of IPA is such that the highest quality at 99.9% is also the most hygroscopic. This means that moisture absorption into both the host container as well as the actual user's container begins with the time the original container is opened and continues as amounts are transferred and removed from both. A 2012 laboratory study by KOMSHINE noted that 99.9% IPA began to absorb moisture (at 72F and 65% Relative Humidity) within fifteen minutes. Since there is no provision to deter this, this unique quality of IPA makes it less desirable than chemicals such as HFE-7100 based products or precision hydrocarbons. There is work being done to qualify aqueous based cleaners for this application.
3. Cleaving the fiberThe fiber is then cleaved using the score-and-break method so that its end-face is perfectly flat and perpendicular to the axis of the fiber. The quality of each fiber end is inspected using a microscope. In fusion splicing, splice loss is a direct function of the angles and quality of the two fiber-end faces. The closer to 90 degrees the cleave angle is the lower optical loss the splice will yield. The quality of the cleave tool being used is critical.
4. Splicing the fibersCurrent fusion splicers are either core or cladding alignment. Using one of these methods the two cleaved fibers are automatically aligned by the fusion splicer in the x,y,z plane, then are fused together. Prior to the removal of the spliced fiber from the fusion splicer, a proof-test is performed to ensure that the splice is strong enough to survive handling, packaging and extended use. The bare fiber area is protected either by recoating or with a splice protector. A splice protector is a heat shrinkable tube with a strength membrane and less loss.
We are here to help you! If you close the chatbox, you will automatically receive a responsefrom us via email. Please be sure to leave yourcontact details so that we can better assist