FOT

How to change fiber welding electrical pole?

by:FOT     2020-11-08
Replacing electrode welding machines to remove the protection of the electrode chamber cover, loosen screw is fixed on the electrode, remove the electrodes. Then loosen the fixed under the crest of the electrode wire, remove the electrode. The installation of a new electrode order and remove the action on the contrary, require two electrode tip clearance for: 2. 6± 0. 2 mm, with and symmetry. Normally the electrode is not adjusted. In the process of change should not touch the electrode tips, in case of damage, and should avoid electrode inside the machine. After replacement of electrode shall be arc position calibration, the process is as follows: 1. Optical fiber welding electrical source switch set & other; Open & throughout; Position, open the welding machine. 2. Press & other; Parameter & throughout; The state of level 1 menu. 3. Press & other; ▲ ” Or & other ▼ ” Make the cursor arrow & other; → ” Pointing & other; Throughout & maintenance mode; Items. 4. Press & other; Confirm & throughout; The maintenance menu key,. 5. Press & other; ▲ ” Or & other ▼ ” Make the cursor arrow & other; → ” Pointing & other; Clean the electrode & throughout; Items. 6. Press & other; Confirm & throughout; Key, then the machine automatically arc discharge to large current arc produced by high temperature will be deposited on the surface of the electrode, evaporation of impurities, to achieve stable discharge current, clean electricity pole and the effect of the aging of the new electrode. 7. Press & other; ▲ ” Or & other ▼ ” Make the cursor arrow & other; → ” Pointing & other; Arc position & throughout; Items. 8. See the foregoing, install left fiber end face, make the fiber end face and upper and lower electrode tip line of three point one. 9. Press & other; Confirm & throughout; Key, then the machine automatically arc discharge, the user is able to open the right welding machine clamp, and the relative position of electric arc. By adjusting the electrode gap to achieve the goal of is located in the middle of arc. 10. Press & other; Parameter & throughout; Key, exit menu state in turn.
Fibra Opticas Tek Technology Co., Ltd. is one of the most-trusted manufacturing suppliers to the domestic markets.
Knowing these basics of is every essential. But if you don't know how to choose the proper for your specific need, let Fibra Opticas Tek Technology Co., Ltd. experts be your guide. Enquire us at Fibra Opticas Tek.
Fibra Opticas Tek Technology Co., Ltd. sells china fiber optic manufacturer and yet their focus on operational excellence and mastery of distributed manufacturing facilities fiber optic manufacturers in china has made them the dominant player in the space.
Custom message
Chat Online
Chat Online
Chat Online inputting...