FOT

FS - Type N11CP Keyence Keyence digital fiber optic sensor spot

by:FOT     2020-11-25

FS - Type N11CP Keyence Keyence digital fiber optic sensor technology parameters:

type

the FS - Type N11CP

standard single-channel output M8 interface * 1

the main unit/extension unit

the main unit output

control

1 PNP open collector 24 V; Single channel output value: 100 mA or less; Dual output (GDP) : 100 mA or lower ( Used alone) / 20 mA, or lower ( Multiple connection) ; Residual voltage 1 V or lower

monitor output ( 1 - 5 V)

-

external input

1 input time 2 ms ( 上) /20 ms( 关闭) Or longer, When selecting an external calibration for 25 or more (ms 开/关) ) Response time

50 & micro; s( 高速) /250 µ s( 很好) /500 µ s( TURBO) /1 ms( 超级) /4 ms( ULTRA) /16 ms( MEGA)

connect to multiple expansion unit

how can connect 16 ( Dual output type are seen as two units) Light source

red 4 elements LED

APC

can switch ON/OFF ( Factory Settings: OFF) Anti-jamming unit number

HIGH SPEED without; Four FINE. TURBO/SUPER/ULTRA/MEGA 8 个( When set to double, anti-interference unit will double the number of) Rated capacity

voltage

12 - 24伏直流电± Ripple (10% P - P) 10% or less

current consumption

standard mode: 950 mW or less ( 12 V 24 V when 39 mA, 52 mA) * 2 eco on mode: 850 mW or less ( When the 24 V 35 mA, 12 V when big 44 mA) * 2 eco Full mode: 520 mW or less ( When the big 21 mA 24 V, 12 V big 26 mA)

environment patience

running environment brightness

incandescent lamp: 20000 lux or less; Fluorescent lamp: 30000 lux or lower

running environment temperature

- 20 and 55 + & deg; C( No freezing) * 3

running environment humidity

35 to 85% RH ( No condensation)

extent

10 to 55 Hz, complex amplitude of 1. 5 mm, XYZ axis 2 hours each axis

impact resistance

500 m/s2XYZ axis each axis three

the shell material

the main unit and extension unit shell material is polycarbonate

weight

about 22 g

* 1 for M8 mouth, use cable length is less than 30 m. * 2 100 mW (high-speed mode to improve 4. 0 mA) * 3 to connect one or two units: - 20 and 55 + & deg; C; Connect 3 to 10 units: - 20 to 50 + & deg; C; Connect 11 to 16 units: - 20 to + 45 & deg; C。 Using a dual output, a unit is meter for two. All temperature rules applicable conditions are put on the DIN rail unit and installed on the sheet metal.

Custom message
Chat Online
Chat Online
Chat Online inputting...